From 2327e9953739361bde0d7d9b46da735e6c6ec22c Mon Sep 17 00:00:00 2001
From: dakkar <dakkar@thenautilus.net>
Date: Fri, 25 Mar 2022 14:05:26 +0000
Subject: different middle: no bottom

---
 enclosure/enclosure.scad | 18 +++++++++---------
 1 file changed, 9 insertions(+), 9 deletions(-)

diff --git a/enclosure/enclosure.scad b/enclosure/enclosure.scad
index 992b591..1a33123 100644
--- a/enclosure/enclosure.scad
+++ b/enclosure/enclosure.scad
@@ -50,7 +50,7 @@ DISPLAY_Y_OFF=6.1;
 BOARD_X=66.5;
 BOARD_Y=36.8;
 BOARD_SINK=2.2;
-BOARD_PAD=2;
+BOARD_PAD=0;
 
 BOARD_PIN_OFF_X=2.35; BOARD_PIN_DIST_X=61.43;
 BOARD_PIN_OFF_Y=2.15; BOARD_PIN_DIST_Y=32.5;
@@ -160,19 +160,19 @@ module co_holes() {
 }
 
 module middle_cable_well() {
-  box([
+  cube([
        20, // doesn't matter, wells at both sides are much wider
        CO_CONN_Y,
-       CO_Z,
-       ]);
+       200,
+        ], center=true);
 }
 
 module board_well() {
-  box([ BOARD_X+BOARD_PAD, BOARD_Y+BOARD_PAD, CO_Z]);
+  cube([ BOARD_X+BOARD_PAD, BOARD_Y+BOARD_PAD, 200], center=true);
 }
 
 module board_support() {
-  HEIGHT=MIDDLE_Z - WALL_THICKNESS - BOARD_SINK;
+  HEIGHT=MIDDLE_Z - BOARD_SINK;
   EXTRA=BOARD_SUPPORT_DIAM*2;
 
   translate([0,0,HEIGHT/2]) union() {
@@ -284,13 +284,13 @@ module middle() {
       screw_holes();
       translate([CABLE_HOLE_X_OFF, CABLE_HOLE_Y_OFF, 0]) cable_hole();
       translate([CO_X_OFF, 0, CO_Z_OFF]) co_sensor();
-      translate([CABLE_X_OFF, 0, CO_Z_OFF]) middle_cable_well();
+      translate([CABLE_X_OFF, 0, 0]) middle_cable_well();
       translate([BOARD_X_OFF, BOARD_Y_OFF, 0]) {
-        translate([0,0, CO_Z_OFF]) board_well();
+        translate([0,0, 0]) board_well();
         translate([0,0, BOARD_Z_OFF]) outside_wells();
       }
     }
-    translate([BOARD_X_OFF, BOARD_Y_OFF, CO_Z_OFF]) board_supports();
+    translate([BOARD_X_OFF, BOARD_Y_OFF, 0]) board_supports();
   }
 }
 
-- 
cgit v1.2.3