From 0613bb28883b72062adb38ac5dbde6dee7075c69 Mon Sep 17 00:00:00 2001 From: dakkar Date: Sat, 5 Feb 2011 11:11:46 +0000 Subject: SF35 initial profile --- profiles/extrusion/ABS/raft.csv | 34 ++++++++++++++++++++++++++++++++++ 1 file changed, 34 insertions(+) create mode 100644 profiles/extrusion/ABS/raft.csv (limited to 'profiles/extrusion/ABS/raft.csv') diff --git a/profiles/extrusion/ABS/raft.csv b/profiles/extrusion/ABS/raft.csv new file mode 100644 index 0000000..ab0a273 --- /dev/null +++ b/profiles/extrusion/ABS/raft.csv @@ -0,0 +1,34 @@ +Format is tab separated raft settings. +Name Value +WindowPosition 700+0 +Open File for Raft +Activate Raft True +Add Raft, Elevate Nozzle, Orbit and Set Altitude: True +Base Feed Rate Multiplier (ratio): 0.6 +Base Flow Rate Multiplier (ratio): 1.0 +Base Infill Density (ratio): 0.5 +Base Layer Thickness over Layer Thickness: 2.0 +Base Layers (integer): 1 +Base Nozzle Lift over Base Layer Thickness (ratio): 0.8 +Initial Circling: False +Infill Overhang over Extrusion Width (ratio): 0.05 +Interface Feed Rate Multiplier (ratio): 1.4 +Interface Flow Rate Multiplier (ratio): 1.0 +Interface Infill Density (ratio): 0.65 +Interface Layer Thickness over Layer Thickness: 1.2 +Interface Layers (integer): 1 +Interface Nozzle Lift over Interface Layer Thickness (ratio): 0.2 +Object First Layer Feed Rate Infill Multiplier (ratio): 0.65 +Object First Layer Feed Rate Perimeter Multiplier (ratio): 0.75 +Object First Layer Flow Rate Multiplier (ratio): 1.0 +Operating Nozzle Lift over Layer Thickness (ratio): 1.2 +Raft Additional Margin over Length (%): 1.3 +Raft Margin (mm): 5.0 +Support Cross Hatch False +Support Flow Rate over Operating Flow Rate (ratio): 1.0 +Support Gap over Perimeter Extrusion Width (ratio): 6.0 +None False +Empty Layers Only False +Everywhere False +Exterior Only True +Support Minimum Angle (degrees): 46.0 -- cgit v1.2.3