Format is tab separated raft settings.
Name Value
WindowPosition 700+0
Open File for Raft
Activate Raft True
Add Raft, Elevate Nozzle, Orbit and Set Altitude: True
Base Feed Rate Multiplier (ratio): 0.6
Base Flow Rate Multiplier (ratio): 1.0
Base Infill Density (ratio): 0.5
Base Layer Thickness over Layer Thickness: 2.2
Base Layers (integer): 1
Base Nozzle Lift over Base Layer Thickness (ratio): 0.4
Initial Circling: False
Infill Overhang over Extrusion Width (ratio): 0.05
Interface Feed Rate Multiplier (ratio): 1.4
Interface Flow Rate Multiplier (ratio): 1.0
Interface Infill Density (ratio): 0.4
Interface Layer Thickness over Layer Thickness: 1.4
Interface Layers (integer): 2
Interface Nozzle Lift over Interface Layer Thickness (ratio): 0.5
Object First Layer Feed Rate Infill Multiplier (ratio): 0.65
Object First Layer Feed Rate Perimeter Multiplier (ratio): 0.75
Object First Layer Flow Rate Multiplier (ratio): 1.0
Operating Nozzle Lift over Layer Thickness (ratio): 1.0
Raft Additional Margin over Length (%): 1.3
Raft Margin (mm): 5.0
Support Cross Hatch False
Support Flow Rate over Operating Flow Rate (ratio): 1.0
Support Gap over Perimeter Extrusion Width (ratio): 6.0
None False
Empty Layers Only False
Everywhere False
Exterior Only True
Support Minimum Angle (degrees): 46.0